Mute

This parameter enables/disables the editing of mute parameter for each bend in the program edit cycle.

When this parameter is ON, the mute point can be changed for each individual bend of a program.

This parameter defines a tolerance for the 'Mute changed' signal in the PLC.

If there is a difference in the programmed and actual (from Laser safe) Mute point, a PLC flag is set within the RA software to signal the Mute has changed. If this signal is not necessary for small changes of Mute, a tolerance can be programmed with this parameter. If the difference between new and old Mute point is larger than this tolerance, the flag is set. This parameter is irrelevant if the flag is not used in PLC.

This parameter defines the mute distance additional to computed value.

To program an alternative mute position intended to stop the beam at a higher mute position.

This parameter defines the minimum mute value of every V-die.

The mute value that is programmed in the parameters of every V-die, is limited to this machine parameter value. The operator cannot program a value that is lesser than this parameter.